Send us a DXF and you get the part back — nested, cut, deburred and folded. Laser cutting removes the tolerance stack that comes from marking out and manual cutting, which matters most on assemblies where twenty parts have to line up at once.
The same machine handles both ends of the work: structural gussets and base plates in heavy plate, and fine decorative screen patterns where the cut width itself is part of the design. Nesting is optimised before cutting, so material cost stays down on volume runs.
Clean, burr-free cutting across mild steel, stainless and aluminium with tight, repeatable edge tolerances.
Programmed bending sequences for boxes, brackets, cladding returns and folded panels.
Rolling of plate and sections into curves and cylinders for tanks, hoppers and curved architectural work.
Intricate screen and mashrabiya patterns nested to run continuously across multiple panels.
One-off prototypes through to repeat production batches from the same approved program.
Edge deburring, linishing and surface preparation ready for welding, coating or direct installation.
Send us your drawings, samples or a description of the scope. Our engineering team will come back with a detailed quotation and a realistic programme.
