Piping work lives or dies on documentation. Every joint is mapped, every welder is qualified to the applicable procedure, and every line ends up in a test pack that ties the weld back to the person who made it and the NDT report that cleared it.
Fabricating spools in the workshop and installing them as assemblies cuts the number of position welds needed at height. That reduces the hot-work exposure on site, shortens the shutdown window and produces a more consistent weld than the same joint made on a scaffold.
Workshop-fabricated pipe spools cut, bevelled, fitted and welded from isometrics before shipping to site.
Qualified welders working to approved WPS, with GTAW root and SMAW/GMAW fill and cap as specified.
Shoes, guides, anchors, spring hangers and full pipe rack steelwork fabricated and installed with the line.
Erection, alignment, bolt-up and tie-in of new lines into existing systems under permit.
Hydrostatic and pneumatic testing, radiography and dye-penetrant inspection with complete test packs.
Surface preparation, painting and provision for thermal or personnel-protection insulation.
Send us your drawings, samples or a description of the scope. Our engineering team will come back with a detailed quotation and a realistic programme.
